Fittings and drilling checks
Generate drilling after the structure is settled
Hole positions depend on the latest panel geometry and fitting settings. Complete the structure before generating and checking drilling.
- Confirm board thickness, joint methods, doors, drawers and back construction.
- Generate holes and fittings; use messages to locate parts without support or suitable mounting conditions.
- Inspect individual panels for machining face, hole position, diameter and depth.
If editing parts marks drilling as outdated, regenerate before export. Do not reuse the earlier machining package.
Distinguish joints from shelf supports
Cam fittings, confirmat screws and adjustable-shelf supports have different mounting requirements. A visible hole alone does not prove a valid joint.
- Check edge-to-face connections against the chosen fitting method.
- Check thick screwed backs for confirmat construction and adjustable shelves for supports and system holes.
- Compare holes and fitting quantities with the actual products, including matching holes on both connected panels.
The 32 mm system is a hole-spacing scheme, not a guarantee that every fitting is interchangeable.
Check hinges, slides, handles and clothes rods
Fitting positions must correspond to moving and load-bearing parts. Use the model and mounting centres of the products actually selected.
- Check hinge side, cup holes and mounting-plate faces, including available door space.
- Check slide length and mounting side, handle centres and orientation, and rod end supports.
- Regenerate drilling after changing fittings and compare the fittings list with the model.
Previews help locate parts. Before a production run, check the fitting instructions and make a trial assembly.